A customer here in York, PA has only had their Lantech machine 3 years and has replaced the load seeking clamp 3 times.

They have struggled with the clamps suction method popping holes in the film and not holding it, as well as and welds breaking.

We suggested a different method and design in the Wulftec clamp system.

This system is mounted away from the conveyor, further back than the rotating arm and holds the film without using suction.

We changed the program and installed this clamp in approximately 4 hours to minimize downtime.  Now the machine requires very little attention, like a fully automatic machine should be!

Sold, Installed, and Programmed by John Koehler